- +1 203 729 9000
- hbarber@hbarber.com
- Mon - Fri: 9:00 - 18:00 EST
SURF RAKE service
ADJUSTING THE SURF RAKE'S 8" & 3.5" IDLER ROLLER BEARINGS
Play Video about adjusting the idler roller
REQUIRED TOOLS
Snapring Pliers
New Shims
FREQUENCY
Only as needed if substantial looseness is noticed in the idler roller’s bearing.
QUESTIONS?
Contact a Barber team member at:
(800) 355-8318 or
hbarber@hbarber.com
VIDEO TRANSCRIPT
Once you’ve determined a roller bearing needs adjustment, remove it from the machine and put it in a vice.
Utilizing a pair of snapring pliers, remove the outer snapring on the face of the roller. Once removed, take the top cover off and clear excess grease to expose the inside snapring and shims. Remove the inner snapring with the snapring pliers.
Next, install the additional shims into the roller. Use as many shims as necessary so that the snapring fits firmly in place.
Once the appropriate shims are in place, reinstall the inner snapring. Confirm that it is firmly seated inside the groove of the roller shaft.
Lastly, install the outer cover and snapring. Confirm that it is seated inside the groove of the roller. Re-check the roller for any play. If there is still any unsteadiness, you must add additional shims.
Once finished, reinstall the roller back onto the machine.